Am 29.05.2009 um 09:06 schrieb Jayadevan M:

> If your .so is 32 bit, you need to get the right so (64 bit) and have
> everything in 64 bit mode.
> Sometimes both sets are present in the system and if you point it to
> the right one, it will work. Please try a find command for that .so
> file and see if both are available (32 bit and 64 bit). If they are,
> you can use the 64 bit so path during configure/compile.
> There is a switch available to compile in 64 bit mode.  Please see
> this link
> http://www.linuxquestions.org/questions/linux-software-2/compiling-php-on-rhel-5-64-bit-685606/
> Regards,
> Jay
>



Ok, but this is Solaris:

-bash-3.00# ./configure --with-pgconfigdir=/usr/postgres/8.3/bin -- 
with-pglibdir=/usr/postgres/8.3/lib/amd64 --with-perltools

....

checking for POSIX signal interface... yes
checking if you have requested slony1-engine building... yes
overriding pglibdir with /usr/postgres/8.3/lib/amd64
checking for pg_config... /usr/postgres/8.3/bin/pg_config
pg_config says pg_bindir is /usr/postgres/8.3/bin/
pg_config says pg_includedir is /usr/postgres/8.3/include/
pg_config says pg_pkglibdir is /usr/postgres/8.3/lib/
pg_config says pg_includeserverdir is /usr/postgres/8.3/include/server/
checking for correct version of PostgreSQL... 8.3
8.3
pg_config says pg_sharedir is /usr/postgres/8.3/share/
checking PostgreSQL for enable-thread-safety as required on  
solaris2.10... yes
checking for PQunescapeBytea in -lpq... no
configure: error: Your version of libpq doesn't have PQunescapeBytea
      which means that your version of PostgreSQL is lower than 7.3
      and thus not even remotely supported by Slony-I version 2
./configure: line 7489: exit: which: numeric argument required
./configure: line 7489: exit: which: numeric argument required
-bash-3.00#


And now?


Best Regards,
Rainer